NXP_ARM_LS2088A
LS2088A training course
This course explains the architecture of the LS2088A to enable participants to efficiently design a board and implement the integrated memory controllers and peripherals
Target audience
Board designers, boot and driver software developers
Prerequisites
Experience with a processor or DSP is mandatory
See courses ARM_CA_A72, CVT_GP_PCIE34, CVT_GP_USB3, CVT_MS_EMMC, CVT_MS_SATA, NET_STD_ETH, NET_STD_PTP and DRAM_DDR4
Hands-on
Based on LS2088A board, GCC toolchain and TRACE32 debugger
Agenda
DAY1
- Architecture of LS2088A
- Interconnect
- System MMU, MMU500
- Power, clocking and reset
DAY2
- Trust architecture
- Power management
- PCIe bridge
- Memory controllers
DAY3
- Mass storage interfaces
- Low speed serial interfaces
- Queue direct memory access (qDMA)
- USB controllers
- FlexTimer module
DAY4
- DPAAv2 overview
- Ethernet MACs
- Queue buffer manager
- Wire rate IO processor
DAY5
- WRIOP classifier and table lookup unit (WRIOP-CTLU)
- Parser (WRIOP-CTLU)
- CTLU QOS mapping and policer
- Multi field lookup unit (MFLU)
- AIOP classifier and table lookup unit
DAY6
- L2 switch address resolution
- MACSEC
- Security engine
- Pattern match engine
- Decompression and compression engine (DCE)
Teaching methods
Lectures with supporting slides, demos and case studies
Review and execution of practical examples, provided by MOVE.B, using GCC compiler and Lauterbach TRACE32 debugger
Related products
Board design, schematics review, pre-layout review
SoC performance improvement
Bare-metal driver design
DDR4 controller initialization from DDR4 device’s data sheet
Included with every course
On-site session, contents tailored to your needs
Training manuals in PDF format
Certificate of completion for every attendee
Trainers who follow the vendors' train-the-trainer programmes
Questions
Can the course be tailored to our project?
Yes. You choose the chapters, how deep each one goes and the boards used in the labs. We send you the programme to review before the session.
Do the attendees get a certificate?
Yes. Every attendee receives a certificate of completion of the course.
Where does the session take place?
Usually at your premises. The trainer brings the evaluation boards used in the labs.
How many attendees can join?
Small or large groups: tell us how many engineers will attend when you request the course.
What course material do the attendees receive?
The training manuals in PDF format.
Who are the trainers?
Engineers who follow the vendors' train-the-trainer programmes and work on these devices in their own projects.
How do we book a session?
Use "Request this course" with the number of attendees, the place and the device of your project. We reply with the programme and agree on the dates with you.
Same family