NXP_ARM_LX2160A

LX2160A training course

This course explains the architecture of the LX2160A to enable participants to efficiently design a board and implement the integrated memory controllers and peripherals

Target audience

Board designers, boot and drivers software developers

Prerequisites

Experience with a processor or DSP is mandatory
See courses ARM_CA_A72, CVT_GP_PCIE34, CVT_GP_USB3, CVT_MS_EMMC, CVT_MS_SATA, CVT_AA_CAN, NET_STD_ETH, NET_STD_PTP and DRAM_DDR4

Hands-on

Based on LX2160A board, GCC toolchain and TRACE32 debugger

Agenda

DAY1
  • Architecture of LX2160A
  • Interconnect
  • System MMU, MMU500
  • Power, clocking and reset
DAY2
  • Trust architecture
  • Power management
  • PCIe bridge
  • Memory controllers
DAY3
  • Mass storage interfaces
  • Low speed serial interfaces
  • Queue direct memory access (QDMA)
  • USB controllers
  • FlexTimer module
DAY4
  • DPAAv2 overview
  • Ethernet MACs
  • Queue buffer manager
DAY5
  • Wire rate IO processor
  • WRIOP classifier and table lookup unit (WRIOP-CTLU)
  • Parser (WRIOP-CTLU)
  • CTLU QoS mapping and policer
DAY6
  • L2 switch address resolution
  • MACSEC
  • Security engine
  • Decompression and compression engine (DCE)

Teaching methods

Lectures with supporting slides, demos and case studies
Review and execution of practical examples, provided by MOVE.B, using GCC compiler and Lauterbach TRACE32 debugger

Related products

Board design, schematics review, pre-layout review
SoC performance improvement
Bare-metal driver design
DDR4 controller initialization from DDR4 device’s data sheet

Included with every course

On-site session, contents tailored to your needs
Training manuals in PDF format
Certificate of completion for every attendee
Trainers who follow the vendors' train-the-trainer programmes

Questions

Can the course be tailored to our project?

Yes. You choose the chapters, how deep each one goes and the boards used in the labs. We send you the programme to review before the session.

Do the attendees get a certificate?

Yes. Every attendee receives a certificate of completion of the course.

Where does the session take place?

Usually at your premises. The trainer brings the evaluation boards used in the labs.

How many attendees can join?

Small or large groups: tell us how many engineers will attend when you request the course.

What course material do the attendees receive?

The training manuals in PDF format.

Who are the trainers?

Engineers who follow the vendors' train-the-trainer programmes and work on these devices in their own projects.

How do we book a session?

Use "Request this course" with the number of attendees, the place and the device of your project. We reply with the programme and agree on the dates with you.