NXP_ARM_LS1021A

LS1021A training course

This course explains the architecture of the LS1021A to enable participants to efficiently design a board and implement the integrated memory controllers and peripherals

Target audience

Board designers, boot and driver software developers

Prerequisites

Experience with a processor or DSP is mandatory
See courses ARM_CA_A7, CVT_GP_PCIE12, CVT_GP_USB3, CVT_MS_EMMC, CVT_MS_SATA, CVT_AA_CAN, NET_STD_ETH, NET_STD_PTP and DRAM_DDR4

Hands-on

Based on LS1021A board, GCC toolchain and TRACE32 debugger

Agenda

DAY1
  • Architecture of LS1021A
  • Interconnect
  • System MMU, MMU400
  • Power, clocking and reset
DAY2
  • Trust architecture
  • Run control and power management
  • PCIe bridge
  • Memory controllers
DAY3
  • Mass storage interfaces
  • Low speed serial interfaces
  • Enhanced direct memory access (eDMA)
  • Queue direct memory access (qDMA)
  • Two-dimensional animation and compositing engine (2D-ACE)
  • USB controllers
DAY4
  • Enhanced three speed Ethernet controllers
  • Audio subsystem modules
DAY5
  • QUICC engine- system interface
  • QUICC engine- buffer management
  • QUICC engine- unified communication controllers
  • QUICC engine- UCC HDLC controller
  • QUICC engine- UCC transparent controller
  • Multi-channel controller on UCC- UMCC

Teaching methods

Lectures with supporting slides, demos and case studies
Review and execution of practical examples, provided by MOVE.B, using GCC compiler and Lauterbach TRACE32 debugger

Related products

Board design, schematics review, pre-layout review
SoC performance improvement
Bare-metal driver design
DDR4 controller initialization from DDR4 device’s data sheet

Included with every course

On-site session, contents tailored to your needs
Training manuals in PDF format
Certificate of completion for every attendee
Trainers who follow the vendors' train-the-trainer programmes

Questions

Can the course be tailored to our project?

Yes. You choose the chapters, how deep each one goes and the boards used in the labs. We send you the programme to review before the session.

Do the attendees get a certificate?

Yes. Every attendee receives a certificate of completion of the course.

Where does the session take place?

Usually at your premises. The trainer brings the evaluation boards used in the labs.

How many attendees can join?

Small or large groups: tell us how many engineers will attend when you request the course.

What course material do the attendees receive?

The training manuals in PDF format.

Who are the trainers?

Engineers who follow the vendors' train-the-trainer programmes and work on these devices in their own projects.

How do we book a session?

Use "Request this course" with the number of attendees, the place and the device of your project. We reply with the programme and agree on the dates with you.