NET_STD_ETH

Ethernet training course

This course aims to enable participants to design, verify or debug Ethernet 1/10/25/40/50/100 Gbps IPs and links. Participants get a detailed understanding of the Ethernet and TCP/IP protocols. The attendees will learn about Ethernet hardware and software implementation. Latest specifications, such as AVB will be studied.

Target audience

Architects, board designers, verification engineers, firmware developers

Prerequisites

Experience of a digital bus is mandatory.

Hands-on

Wireshark is used to capture and display Ethernet traffic to facilitate the understanding of the protocol.

Agenda

DAY1
  • Introduction to Ethernet
  • MAC layer
  • Management layer
  • Optical link basics
  • 100 Mbps networks
DAY2
  • 1000 Mbps networks
  • 1000BASE-T
  • 1000BASE-X, including backplane Ethernet 1000BASE-KX
DAY3
  • Introduction to Ethernet 10G
  • MAC / PHY interface
  • Management interface
  • 10GBASE PHY layers
  • 1G/10G/40G backplanes
  • Ethernet 25G/40G/50G/100G
  • MAC-to-PHY interface and interfaces between PHY sub-layers
DAY4
  • Energy efficient Ethernet (EEE, IEEE802.3az)
  • Enhanced small form factor pluggable module SFP+
  • Audio-video bridging (AVB), IEEE802.1BA
  • Switch operation – 802.1, 802.1Q
DAY5
  • Layer 3 protocols
  • Layer 4 protocols
  • Security
  • Implementation of Ethernet in Linux systems
  • Power over Ethernet

Teaching methods

Lectures with supporting slides, demos and case studies
Ethernet traffic capture with WireShark complements the theoretical explanations

Included with every course

On-site session, contents tailored to your needs
Training manuals in PDF format
Certificate of completion for every attendee
Trainers who follow the vendors' train-the-trainer programmes

Questions

Can the course be tailored to our project?

Yes. You choose the chapters, how deep each one goes and the boards used in the labs. We send you the programme to review before the session.

Do the attendees get a certificate?

Yes. Every attendee receives a certificate of completion of the course.

Where does the session take place?

Usually at your premises. The trainer brings the evaluation boards used in the labs.

How many attendees can join?

Small or large groups: tell us how many engineers will attend when you request the course.

What course material do the attendees receive?

The training manuals in PDF format.

Who are the trainers?

Engineers who follow the vendors' train-the-trainer programmes and work on these devices in their own projects.

How do we book a session?

Use "Request this course" with the number of attendees, the place and the device of your project. We reply with the programme and agree on the dates with you.